[an error occurred while processing this directive] [an error occurred while processing this directive][an error occurred while processing this directive] [an error occurred while processing this directive] [an error occurred while processing this directive] [an error occurred while processing this directive] (none) [an error occurred while processing this directive] [an error occurred while processing this directive] [an error occurred while processing this directive] [an error occurred while processing this directive] [an error occurred while processing this directive][an error occurred while processing this directive] [an error occurred while processing this directive][an error occurred while processing this directive] [an error occurred while processing this directive][an error occurred while processing this directive] [an error occurred while processing this directive] [an error occurred while processing this directive] [an error occurred while processing this directive] (none) [an error occurred while processing this directive] [an error occurred while processing this directive] [an error occurred while processing this directive][an error occurred while processing this directive]
 
[an error occurred while processing this directive] [an error occurred while processing this directive]
Skåne Sjælland Linux User Group - http://www.sslug.dk Home   Subscribe   Mail Archive   Forum   Calendar   Search
MhonArc Date: [Date Prev] [Date Index] [Date Next]   Thread: [Date Prev] [Thread Index] [Date Next]   MhonArc
 

Re: [TEKNIK] 2 netkort. Kun det ikke detekteres??



On Fri, 7 Apr 2000 15:19:57 +0200, Michael Rasmussen <sslug@sslug> wrote:
> Hej alle,
> 
> Jeg har et irriterende problem: maskinen vil kun detekte det første netkort.
> Det skal lige siges, at begge kort fungerer ifølge opsætningsprogrammet til
> kortene - begge er baseret på chip fra realtec (ISA 8019).

Har du driveren som modul eller bygget ind i kernen? Hvis det er i kernen burde
lilo append virke - ellers er det i conf.modules (eller modules.conf og måske
nogle andre steder)
 
> Kortene er sat op som følger:
> 
> 1. kort: irq=10 io=0x320
> 2. kort: irq=11 io=0x340
> 
> Følgende er prøvet:
> 
> I lilo.conf:
> 
> append = "ether=10,io=0x320,eth0 ether=11,io=0x340,eth1"

Prøv evt:
 
> I modules.con:
> 
> alias eth0 ne
> options ne io=0x320 irq=10
options eth0 ip=0x320 irq=10
> alias eth1 ne
> options ne io=0x340 irq=11
options eth1 io=0x340 irq=11


-- 
Most kind regards,
Kristian Bjoernskov, <mailto:sslug@sslug>
Novo Nordisk IT, Network - internet.
Phone: +45 4442 3299. Fax: +45 4442 6061


 
Home   Subscribe   Mail Archive   Index   Calendar   Search

 
 
Questions about the web-pages to <www_admin>. Last modified 2005-08-10, 21:38 CEST [an error occurred while processing this directive]
This page is maintained by [an error occurred while processing this directive]MHonArc [an error occurred while processing this directive] # [an error occurred while processing this directive] *